How to flash dm800hd pro with .nfi's and not get NO CA error

[brandan]

Hi everyone i have aquired a dm800 clone and found that the images available. Some do some dont have secondstage bootloader in the .nfi files and using these images on your box with the wrong bootloader can cause NO CA ERROR on your box. I have had this problem and found a fix to repair mine. But in this tut im going to tell you how not to get this so here goes.

I TAKE NO BLAME OR ANYONE ON THIS SITE TAKES NO BLAME FOR YOU DAMAGING YOUR BOX

YOU DO THIS AT YOUR OWN RISK

PLEASE MAKE SURE YOUR NEW IMAGE.nfi IS A PATCHED IMAGE AND NOT A GENUINE IMAGE OR YOUR TUNER WONT WORK WHEN YOU COME TO CONFIGURE IT.



What you need.
1 ) you need the ssbl*.nfi file for you box ( the * is your bootloader ) mine is 76D si i have my .nfi file for just the bootloader.
2 ) the .nfi of the image you wish to flash to your box.
those should be the olny files you need.

Right here we go to flash your box with your browser.

1 ) shutdown your box ( till you get it is now safe to unplug your box message ) when you see that message remove the power source from the rear of your box.

2 ) reconnect the power source in the rear while holding down the power button on the front of your box. After a few seconds you will see *****STOP**** on your box screen with a ip address above it.

3 ) no goto your computer open your browser ( firefox recommended ) in the address bar of your browser put in the ip address that you saw on your box front screen and hit enter.

4 ) Now it should have loaded the boxes ssbl default screen ( little picture with a chip in it with some text links to the top. sides and under it.

5 ) under the picture there is a link to upgrade click it. Now it will take you to a screen where you click browse and load your .nfi file.

6 ) click browse and locate the IMAGE file you want on your box then click ok and click upload.

DONT CLICK REBOOT WHEN FINNISHED OR WHEN IT HAS FLASHED THE IMAGE DONT CLICK REBOOT

7 ) When the flash has finished DONT CLICK REBOOT. in your browser address bar it will say http://ip/FLASH ( ip being your boxes ip address. delete the FLASH from the end and hit enter.
Now it should have taken you back to the bootloaders default screen again.

CLICK UPGRADE again. ( same as step 5 )

8 )Now you will be back at the click browse and flash screen again. CLICK browse and locate your SSBL*.nfi file this file is maybe 500kb big NOT THE IMAGE FILE. The image file is from 30mb to 60mb in size DON'T get them mixed up.

9 ) now load you ssbl*.nfi file and click flash again ( THIS TIME IT TAKES MAYBE A SECOND TO FLASH this is normal as the file is very small )

NOW ONCE THE LAST STEP IS DONE CLICK REBOOT after the file has flashed ( PLEASE MAKE SURE THE SECOND FLASH IS YOUR WORKING BOOTLOADER.nfi and NOT YOUR NEW IMAGE .nfi file )

Now when your box reboots it should boot up like it has just been unboxed and you will need to setup for your tv and do a scan when all settings have been made to your box.

I hope this helps all the newbies with these boxes.

This is my guide and with my learning it is not copied from anywhere else.